Supported hardware
What ships today. The robot list in the plem profile screen is the installed model catalog, and the driver accepts every model in it.
Robots
The profile's robot model must be one of these values.
| Maker | Robot model in the profile | Notes |
|---|---|---|
| Neuromeka | indy7_ | Standard for new devices. Target-pose, straight-line and collision-avoiding planning all work. If the unit's measured kinematics are registered, they are checked at launch and then used; if the check fails, the launch stops |
| Neuromeka | indy7_ | Some devices |
| Neuromeka | indy7 | First generation. Do not use it as the basis for a new setup |
| Huayan | elfin10_ | Elfin 10 L, mostly manual operation (Jog). Not available yet: target-pose planning (plan_), collision-avoiding planning (cuMotion), camera integration (Hand-eye calibration), precise Mastering |
Kinematics and joint limits differ between generations, so the profile's model must match the actual hardware generation exactly. A profile with a model not in the table does not launch; the stack refuses it and lists the supported models.
Grippers
Three grippers are supported. When a gripper is set in the profile, the gripper action interface comes up with the stack.
| Gripper | Profile value | Connection |
|---|---|---|
| OnRobot RG6 | rg6 | Robot tool EtherCAT channel (flange RS-485, 1 Mbit/s 8E1) |
| DH-Robotics AG-95 | ag95 | Robot tool EtherCAT channel (flange RS-485, 115200 8N1). Device ID 1 to 247, default 1 |
| Danhae SFG-FNM2 | danhae_ | Serial (RS-232, Modbus-RTU; default /dev/, 38400) |
The robot tool EtherCAT channel runs through the Neuromeka tool board, so it can only be turned on with a Neuromeka robot. On other robots, saving the profile and launching are refused with the reason. With communication off (gripper_, or Shape and weight only (comms off) in the Pendant's robot setup), any robot uses just the gripper's shape and weight. Turning this channel on reduces the EtherCAT timing margin.
The Danhae shows a width of 0.0 until it opens or closes for the first time.
If the gripper stops answering because a cable came loose or tool power went off, connected in the gripper status turns false and the TUI shows ✗ not answering. It recovers by itself once reconnected.
F/T sensors
| Sensor | Profile value | Robots |
|---|---|---|
| Aidin AFT200-D80 | aft200_ | Neuromeka indy7_ |
It is read through the robot tool board, so there is no wiring to configure. Values are published on /<robot name>/, without gravity compensation. Settings, zeroing and limits: F/T sensor.
If you change the gripper or F/T sensor of a robot that has a camera calibration and save, a warning appears once: the calibration was measured with the old setup, so calibrate the camera again. It does not block saving or launching.
Cameras
| Camera | Connection | JetPack 6 (Humble) | JetPack 7 (Jazzy) |
|---|---|---|---|
| Stereolabs ZED X Mini | GMSL2 | Supported, vendor SDK installer included | Not in the default packages (plem-sensor-stereolabs); contact support |
| Intel RealSense D455 | USB | Supported, standard package | Supported, standard package |
A camera alone does not give collision avoidance against the cell. The perception nodes come up only when a hand-eye calibration measured with the current mounting exists (Launching the stack).