Skip to main content

Supported hardware

What ships today. The robot list in the plem profile screen is the installed model catalog, and the driver accepts every model in it.

Robots​

The profile's robot model must be one of these values.

MakerRobot model in the profileNotes
Neuromekaindy7_v3Standard for new devices. Target-pose, straight-line and collision-avoiding planning all work. If the unit's measured kinematics are registered, they are checked at launch and then used; if the check fails, the launch stops
Neuromekaindy7_v2Some devices
Neuromekaindy7First generation. Do not use it as the basis for a new setup
Huayanelfin10_lElfin 10 L, mostly manual operation (Jog). Not available yet: target-pose planning (plan_trajectory), collision-avoiding planning (cuMotion), camera integration (Hand-eye calibration), precise Mastering

Kinematics and joint limits differ between generations, so the profile's model must match the actual hardware generation exactly. A profile with a model not in the table does not launch; the stack refuses it and lists the supported models.

Grippers​

Three grippers are supported. When a gripper is set in the profile, the gripper action interface comes up with the stack.

GripperProfile valueConnection
OnRobot RG6rg6Robot tool EtherCAT channel (flange RS-485, 1 Mbit/s 8E1)
DH-Robotics AG-95ag95Robot tool EtherCAT channel (flange RS-485, 115200 8N1). Device ID 1 to 247, default 1
Danhae SFG-FNM2danhae_sfg_fnm2Serial (RS-232, Modbus-RTU; default /dev/ttyUSB0, 38400)

The robot tool EtherCAT channel runs through the Neuromeka tool board, so it can only be turned on with a Neuromeka robot. On other robots, saving the profile and launching are refused with the reason. With communication off (gripper_transport: disabled, or Shape and weight only (comms off) in the Pendant's robot setup), any robot uses just the gripper's shape and weight. Turning this channel on reduces the EtherCAT timing margin.

Danhae width reading

The Danhae shows a width of 0.0 until it opens or closes for the first time.

If the gripper stops answering because a cable came loose or tool power went off, connected in the gripper status turns false and the TUI shows ✗ not answering. It recovers by itself once reconnected.

F/T sensors​

SensorProfile valueRobots
Aidin AFT200-D80aft200_d80Neuromeka indy7_v3

It is read through the robot tool board, so there is no wiring to configure. Values are published on /<robot name>/ft_sensor/wrench, without gravity compensation. Settings, zeroing and limits: F/T sensor.

If you change the gripper or F/T sensor of a robot that has a camera calibration and save, a warning appears once: the calibration was measured with the old setup, so calibrate the camera again. It does not block saving or launching.

Cameras​

CameraConnectionJetPack 6 (Humble)JetPack 7 (Jazzy)
Stereolabs ZED X MiniGMSL2Supported, vendor SDK installer includedNot in the default packages (plem-sensor-stereolabs); contact support
Intel RealSense D455USBSupported, standard packageSupported, standard package

A camera alone does not give collision avoidance against the cell. The perception nodes come up only when a hand-eye calibration measured with the current mounting exists (Launching the stack).